Canon CL-811 How to refill color ink cartridge

Refill ink instructions for Canon CL-811 colour cartridge

Drilling to refill ink cartridge:

Make a hole in each arrow (as shown in photo). One for each color. (Cyan, Magenta and Yellow)

Preparation:

Fill the syringe with 5 or 6 cc of ink. Repeat for each color

To remove air from the syringe do the following:
Place the syringe upwards
and gently squeeze until the ink comes out
of the needle.

How to recharge ink Canon CL811 ink cartridge:

For the drilled hole (as shown in first photo) put the needle to the bottom
and inject the ink slowly, gradually removing the needle out.
This is to better spread the ink in the sponge interior.


When ink appears at the hole, the cartridge is complete.

PS: Do the same for each color , Cyan , Magenta and Yelow

Dry and cover the hole with adhesive tape.

Rest:

It is best to rest the cartridge about ten minutes with head down.
Do not rest on an absorbent paper.
This is done in order to distribute the ink evenly over the sponge (Allows ink to flow to the print head).

The ink cartridge is ready for use.

Cartridge Ink yield 210 pages approx.

Canon pg-810 How to refill black ink cartridge

Canon PG-810 black cartridge CH5PG810WN - Instructions for refilling

First Drill to refill ink cartridge:

You must drill a hole in the indicated area. (see the arrow in the picture)

Second preparation:

Now fill the syringe with 15 cc of back ink. Use a needle to collect the ink.

To remove air from the syringe do the following:
Place the syringe upwards
and gently squeeze until the ink comes out
of the needle.

How to recharge ink Canon PG810:

For the drilled hole - as shown in first photo, - put the needle to the bottom
and inject the ink slowly, gradually removing the needle out.
This is to better spread the ink in the sponge interior.


When ink appears at the hole, the cartridge is complete.
Dry and cover the hole with adhesive tape.

Rest:

It is best to rest the cartridge 10 minutes with head down.
Do not rest on an absorbent paper.
This is done in order to distribute the ink evenly over the sponge(Allows ink to flow to the print head).

The cartridge is ready for use.

Ink cartridge yield 220 pages

Canon printer models that use these cartridges Canon PG 810

Pixma iP2770

Pixma iP2772

Pixma MP245

Pixma MP258

Pixma MP268

Pixma MP276

Pixma MP287

Pixma MP486

Pixma MP496

Pixma MP497

Pixma MX328

Pixma MX338

Pixma MX347

Pixma MX357

Pixma MX366

Pixma MX416

Pixma MX426

Refill Canon CL-31 color cartridge

Refill ink instructions for Canon CL-31 cartridge

How to fill Canon cl-31 cartridge colour

Drilling to refill ink cartridge:

Make a hole in each arrow (as shown in photo). One for each color. (Cyan, Magenta and Yellow)

Preparation:

Fill the syringe with 5 cc of ink. Repeat for each color

To remove air from the syringe do the following:
Place the syringe upwards
and gently squeeze until the ink comes out
of the needle.

How to reink canon CL-31 ink cartridge:

For the drilled hole - as shown in first photo, - put the needle to the bottom
and inject the ink slowly, gradually removing the needle out.
This is to better spread the ink in the sponge interior.


When ink appears at the hole, the cartridge is complete.

PS: Do the same for each color

Dry and cover the hole with adhesive tape.

Rest:

It is best to rest the cartridge 10 minutes with head down.
Do not rest on an absorbent paper.
This is done in order to distribute the ink evenly over the sponge(Allows ink to flow to the print head).

The cartridge is ready for use.

Note: Each time the cartridge is removed from the printer an empty cartridge message appears.
To fix it do a cartridge reset

Canon printer models that use these cartridges CL 31

Pixma iP1800

Pixma iP2600

Pixma MP140

Pixma MP190

Pixma MP210

Pixma MP470

Pixma MX300

Pixma MX310

Canon IP4700 reset

The best way to reset Canon Pixma IP4700

Error ink cartridges aren't installed correctly

Primary power off the inkjet printer. Following, while holding Stop/Reset button, power on the printer.
While keeping power button, release Stop/Reset button.
After that push Stop/Reset button two times.
Wait around 20-30 seconds before the led shows “0".
Next press Stop/Reset button 4 times.
Lastly push Power button 2 times. Final action is to turn off the printer's through pressing the power button 1 final time.

The correct way to Reset waste ink counter (Error E16)

Unplug power and also USB cable.
Open door and maintain power button.
Connect power.
Close door, after that release power button.

This printer utilizes the following ink cartridges

Canon PGI-520BK

Canon CLI-521BK

Canon CLI-521C

Canon CLI-521M

Canon CLI-521Y

Reset Canon Pixma IP2600

How to reset Canon ip 2600 Pixma All in one printer

First power off the printer. Next, while holding STOP/RESET button, power on the printer.
While holding POWER button, release STOP/RESET button. Then push STOP/RESET button twice.
Wait about 20-30 second until the LED shows “0″. Then push STOP/RESET button four times.
Finally push POWER button twice. Last step is to turn off the printer by pressing the POWER button one last time.

This printer uses the following ink cartridges

Canon PG-37

Canon PG-40

Canon CL-38

Canon CL-41

Refill Canon PG-50 black ink cartridge

Canon PG-50 black cartridge - Instructions for refilling

First Drill to refill ink cartridge:

You must drill a hole in the indicated area. (see the arrow in the photo)

Second preparation:

Now fill the syringe with 15 cc of back ink. Use a needle to collect the ink.

To remove air from the syringe do the following:
Place the syringe upwards
and gently squeeze until the ink comes out
of the needle.

How to recharge ink Canon PG-50:

For the drilled hole - as shown in first photo, - put the needle to the bottom
and inject the ink slowly, gradually removing the needle out.
This is to better spread the ink in the sponge interior.


When ink appears at the hole, the cartridge is complete.
Dry and cover the hole with adhesive tape.

Rest:

It is best to rest the cartridge 10 minutes with head down.
Do not rest on an absorbent paper.
This is done in order to distribute the ink evenly over the sponge(Allows ink to flow to the print head).

The cartridge is ready for use.

Note: Each time the cartridge is removed from the printer an empty cartridge message appears.
To fix it do a cartridge reset

Ink cartridge yield 220 pages

Canon printer models that use these cartridges Canon PG-50

Canon FAX-JX200

Canon FAX-JX210P

Canon PIXMA iP1600

Canon PIXMA iP1700

Canon PIXMA iP1800

Canon PIXMA iP2600

Canon PIXMA MP140

Canon PIXMA MP150

Canon PIXMA MP160

Canon PIXMA MP170

Canon PIXMA MP180

Canon PIXMA MP190

Canon PIXMA MP210

Canon PIXMA MP450

Canon PIXMA MP460

Canon PIXMA MP470

Canon PIXMA MX300

Canon PIXMA MX310

Canon PowerShot A530/PIXMA MP460 Combo

Refill HP61 Tricolor ink cartridge CH562WN

Refill ink instructions for HP #61 color cartridge

Drilling to refill ink cartridge:

Make a hole in each arrow (as shown in photo). One for each color. (Cyan, Magenta and Yellow)

Preparation:

Fill the syringe with 5 cc of ink. Repeat for each color

To remove air from the syringe do the following:
Place the syringe upwards
and gently squeeze until the ink comes out
of the needle.

How to recharge ink HP61:

For the drilled hole - as shown in first photo, - put the needle to the bottom
and inject the ink slowly, gradually removing the needle out.
This is to better spread the ink in the sponge interior.


When ink appears at the hole, the cartridge is complete.

PS: Do the same for each color

Dry and cover the hole with adhesive tape.

Rest:

It is best to rest the cartridge 10 minutes with head down.
Do not rest on an absorbent paper.
This is done in order to distribute the ink evenly over the sponge(Allows ink to flow to the print head).

The cartridge is ready for use.

Cartridge Ink yield 165 pages approx.